Configuring A Wireless Router In A Handful Of Minutes!

If you buy networking products for the home, they are often a shelf opposite, or perhaps more devices named access point, switch, router and wireless router, the all important look similar and are not really not specify what they are used should.

Right-click on the LAN that corresponds to your Ethernet card. If you have a wireless card, you will see two. Select the LAN connection, or one that is permanently connected to the network. Select Properties.

Go to one of the sites online tools that identify your current IP address. Once web page is loaded, you will probably see an automatically display your current IP.

DHCP ME – If you do not have a manual TCP / IP address, your wireless router has activated its DHCP server. Connected to your web interface and turn off the DHCP server. Then go to the icon for the wireless network in the lower right corner, and disable your wireless network adapter and then activate. This will renew your DHCP request to the DHCP server router.

Therefore, it is the PC attacker who sees all traffic on the network. And if this attack is focused on a single PC, the attacker can simply tear the PC with its own victims per se and only impact on the network. The PC must be attackers really fast as the gateway large routing tables and many meetings has run in parallel. Most ordinary PC can not handle a large influx of data that caused the system to freeze or crash. This happens when the PC attacker simply not compatible and the number of packets not discarded the PC with the movement of large volumes of data.

Connect an Ethernet cable to one of the Ethernet ports on the switch on the computer. Make sure the lights on the switch and the Ethernet card are green in the computer and wait 30 seconds.

With cable Internet, it was very easy to set up different operating systems to access the Internet, including some versions of Linux, all versions of Microsoft Windows and Mac OS 9 and Mac OS X. No special software required. I wanted to know only the IP address 10.0.0.1 and my main computer, which was connected to the cable modem. This is very simple, by allowing you to find the command “ipconfig” in the command line in a DOS window.

To begin, you must configure your PC to accept a remote connection. To do this, right click on “My Computer” and go to properties. Then “Remote Setup” or “remote”. Select “Allow connections from computers running any version of Remote Desktop (less secure) run”, click OK. The computer can now accept remote connections.

Define both the version and encryption methods in their automatic settings. Then you set a password that is both easy to remember and is complex enough to be difficult to guess.